Sierra Classic 2500 4WD V8-6.0L (2007)
occur on any of the four outside door handles on the vehicle. This condition is more prevalent in warmer climates.
Cause
The pins that retain the handle to the base at its forward pivot point can be pulled out of the base (The handle does not fall off of the vehicle). This
occurs in hot temperatures when the handle is pulled in an outboard and rearward motion when opening the door.
Correction
A new clip has been designed to prevent the legs of the fork area of the handle from collapsing and letting the handle pull out. Use the following
procedure to install the clip into the outside door handle assembly.
1. Remove the outside door handle that is experiencing the concern.
-
Use the published procedure in SI for Front Side Door Outside Handle Replacement for front door handle service.
-
Use the published procedure in SI for Rear Side Door Outside Handle Replacement for rear door handle service.
2. With the back of the handle assembly exposed, reposition the handle to properly engage the pivot pins into the handle base. With the handle pivot
pins properly engaged, install the service clip (1).
3. Reinstall the handle to the vehicle and verify its function.
Parts Information
Warranty Information
For vehicles repaired under warranty, use the table above.
Disclaimer
Technical Service Bulletin # 08-08-64-007
Date: 080513
Body - Outside Door Handle(s) Squeak When Operated
TECHNICAL
Bulletin No.: 08-08-64-007
Date: May 13, 2008
