Sierra Classic 2500 4WD V8-6.0L (2007)
Seat Back: Service and Repair
Front Seat Back Cushion Cover and Cushion Pad Replacement
Front Seat Back Cushion Cover and Cushion Pad Replacement
Removal Procedure
1. Remove the head restraint. Refer to Head Restraint Replacement .
2. Remove the seat trim panel. Refer to Front Seat Trim Panel Replacement .
3. Remove the nut from the lower seat belt anchor.
4. Disengage the J-strip retainer on the bottom of the seat back cover.
5. Disconnect the heater seat element connector, if equipped.
6. Using a side motion, carefully lift the seat back cover partially off the foam pad in order to access the arm rest clip.
7. Remove the armrest, if equipped. Refer to Front Seat Armrest Replacement .
8. Using a flat-bladed tool, lift the seat cover over the air bag cover.
9. Remove the seat cover to the top of the seat.
10. Disengage the panel fasteners in order to remove the rear cardboard panel.
11. Unclip the head restraint retainers. Refer to Front Seat Head Restraint Retainer Replacement .
12. Remove the bolts which retain the seat belt tower cover.
13. Remove the seat belt tower cover.
