Sierra Classic 2500 4WD V8-6.0L (2007)
4. Using a drill with a 5/16 drill bit, or equivalent, pierce holes through the trim and plastic J-retainer at the marked locations on each end of the seat
cushion trim.
5. Pushing only approximately 1/4 of the way through, insert a push pin retainer (1) into the drilled holes on each side of the J-retainer.
6. Reposition the seat cushion and cover, and roll the J-retainer and trim to install position.
7. Attach the J-retainer to the seat cushion pan on one side by positioning the push pin retainer (1) to the rear side of the slot on cushion pan, and
pushing forward to fully seat the push pin in the slot.
8. Repeat step 7 on the opposite end of J-retainer.
9. The seat cushion cover will now have better retention to the seat frame, and exhibit an improved fit across the forward edge of the seat.
Parts Information
Purchase the tape locally.