Sierra Classic 2500 4WD V8-6.0L (2007)
1. Install the door module into the switch panel bezel until it snaps into place.
2. Install the switch panel bezel and module to the door panel.
3. NOTE: Refer to Fastener Notice.
Install the screw that retains the switch panel bezel (1) to the front door panel.
Tighten the screw to 2 N.m (18 lb in).
4. Connect the electrical connectors.
5. Install the front door trim panel.
6. If equipped with camper mirrors, program the door module. Refer to Door Control Module Programming and Setup.
7. Refer to Control Module References for programming and setup information. See: Testing and Inspection/Programming and Relearning
