Sierra Classic 2500 4WD V8-6.0L (2007)
Install the brake caliper bracket bolts.
Tighten the bolts to 200 Nm (148 ft. lbs.).
11. Install the tire and wheel assembly.
12. With the engine OFF, gradually apply the brake pedal to approximately 2/3 of its travel distance.
13. Slowly release the brake pedal.
14. Wait 15 seconds, then repeat steps 13-14 until a firm pedal is obtained. This will properly seat the caliper pistons and pads.
15. Fill the master cylinder reservoir to the proper level with clean brake fluid, if necessary. Refer to Master Cylinder Reservoir Filling.
Front Brake Shield Replacement
Front Brake Shield Replacement (25/3500 Series)
Caution: Refer to Brake Dust Caution.
Removal Procedure
1. Remove the hub and bearing assembly.
2. Remove the splash shield.
Installation Procedure
1. Install the splash shield.
2. Install the hub and bearing assembly.
