Sierra Classic 2500 4WD V8-6.0L (2007)
1. Important:
^
Do not reuse the old mounting screws. Always install new mounting screws with the new EBCM.
^
Do not use RTV or any other type of sealant on the EBCM gasket or mating surfaces.
Install the EBCM to the BPMV.
2. Notice: Refer to Fastener Notice in Service Precautions.
Install the new EBCM screws (1).
Tighten the screws to 5 Nm (39 inch lbs.) in an X-pattern.
3. Lower the vehicle.
4. Connect the negative battery cable.
5. If installing a replacement module, program the replacement module. Refer to Control Module References. See: Testing and
Inspection/Programming and Relearning
6. Turn the ignition to the ON position. DO NOT start the engine.
7. Perform the Diagnostic System Check - Vehicle. See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System Check
- Vehicle
