Sierra Classic 2500 4WD V8-6.0L (2007)
Center Mounted Brake Lamp: Service and Repair
HIGH MOUNT STOP LAMP REPLACEMENT
REMOVAL PROCEDURE
1. Ensure the headlamp switch is in the OFF position.
2. Remove the high mounted stop lamp screws.
3. Remove the high mounted stop lamp from the vehicle.
4. Disconnect the electrical connector.
INSTALLATION PROCEDURE
1. Connect the electrical connector.
2. Install the high mounted stop lamp to the vehicle.
3. NOTE: Refer to Fastener Notice.
Install the high mounted stop lamp screws.
Tighten the high mounted stop lamp screws to 2 N.m (17 lb in).
4. Inspect the operation.
