Sierra Classic 2500 4WD V8-6.0L (2007)
1. Notice:
Refer to Installing Hoses Without Twists or Bends Notice.
Route the hose in the same position the hose occupied prior to removal.
2. Install the power steering gear inlet hose (1) to the brake booster (2). Hand tighten only.
3. Notice:
Refer to Fastener Notice.
Install the power steering gear inlet hose to the power steering gear.
Tighten both power steering gear inlet hose fittings to 28 Nm (20 ft. lbs.).
4. Remove the drain pan from under the vehicle.
5. Bleed the power steering system.
Power Steering Gear Inlet Pipe/Hose Replacement (Without Hydroboost)
Power Steering Gear Inlet Pipe/Hose Replacement (Without Hydroboost)
Removal Procedure
1. Raise the vehicle. Refer to Vehicle Lifting.
2. Remove the engine protection shield.
3. Notice:
Refer to Power Steering Hose Disconnected Notice.
Install a drain pan under the vehicle.
4. Remove the power steering gear inlet hose (3) from the power steering pump (1).
5. Remove the power steering gear inlet hose from the power steering gear.
6. Remove the power steering gear inlet hose from the vehicle.
Installation Procedure
1. Notice:
Refer to Installing Hoses Without Twists or Bends Notice.
Route the hose in the same position the hose occupied prior to removal.
2. Install the power steering gear inlet hose (3) to the power steering pump (1). Hand tighten only.
3. Notice:
