Sierra Classic 2500 4WD V8-6.0L (2007)
Refer to Fastener Notice.
Install the power steering gear inlet hose to the power steering gear.
Tighten both power steering gear inlet hose fittings to 28 Nm (20 ft. lbs.).
4. Remove the drain pan from under the vehicle.
5. Install the engine protection shield.
6. Lower the vehicle.
7. Bleed the power steering system.
Power Steering Gear Outlet Pipe/Hose Replacement (Rack and Pinion)
Power Steering Gear Outlet Pipe/Hose Replacement (Rack and Pinion)
Removal Procedure
Notice:
Refer to Power Steering Hose Disconnected Notice.
1. Remove the power steering outlet hose (4) from the power steering gear (3).
2. Remove the power steering outlet hose (4) from the power steering cooler (5).
Installation Procedure
1. Connect the power steering outlet hose (4) to the power steering cooler (5).
2. Connect the power steering outlet hose (4) to the power steering gear (3). Hand tighten only.
3. Notice:
Refer to Fastener Notice.
Connect the power steering outlet hose (2) to the power steering pump (1).
Tighten both hose connections to 28 Nm (20 ft. lbs.).
4. Bleed the power steering system.
5. Inspect all the hose connections for leaks.
