Sierra Classic 2500 4WD V8-6.0L (2007)
4. Position the J 41364-A onto the PNP switch. Ensure that the 2 slots on the switch where the manual shaft is inserted are lined up with the lower 2
tabs on the tool.
5. Notice:
Refer to Fastener Notice.
Rotate J 41364-A until the upper locator pin on the tool is lined up with the slot on the top of the switch.
Tighten the bolts to 25 Nm (18 ft. lbs.).
6. Remove J 41364-A from the PNP switch. If installing a new switch, remove the positive assurance bracket at this time.
7. Install the control lever to the manual shaft with the nut.
8. Install the manual shaft nut.
Tighten the nut to 25 Nm (18 ft. lbs.).
9. Install the range selector cable end (2) to the range selector lever ball stud (1).
