Sierra Classic 2500 4WD V8-6.0L (2007)
2. Using Three Bond silicone 1207B, GM P/N 97720043, seal the starter solenoid attachment area.
Important: Ensure that the drive gear lever (1) is properly installed into the solenoid plunger (2) loop. Improper installation of the drive
gear lever will cause an abnormal or no operation condition of the starter.
3. Install the solenoid, making sure to insert the drive gear lever (1) into the solenoid plunger (2) loop, perform the following:
1. Pull the gear lever (1) out away from the starter housing and pull the plunger (2) out away from the solenoid.
2. Tip the solenoid and insert the lever into the loop, push the solenoid against the housing.
