Sierra Classic 2500 4WD V8-6.0L (2007)
24. From the technicians point of view, the FRONT of the sensor will have:
^
A flush rotor flange cuff (4)
^
A pin hole (2) for the centering pin-Note the location of the pin hole.
^
An alignment mark (3) on the flush rotor flange cuff (4) for installation
^
A foam ring (1)
25. Remove the connector from the sensor.
26. Remove the sensor from the adapter and bearing assembly.
27. To install the sensor, proceed to step 21 in the installation procedure.
Installation Procedure
1. Important:
If reusing the existing sensor, no centering of the sensor is required.
If installing a new sensor, it will come with a pin installed in the sensor. Do not remove the pin until the sensor is seated.
2. From the technicians point of view, the FRONT of the sensor (1) connector will be on your right. From the technicians point of view, the BACK of
the sensor (2) connector will be on your left.
3. Looking at the FRONT of the sensor, align the sensor with the steering shaft and install into the adapter and bearing assembly.
4. Install the connector to the sensor.
5. From the technicians point of view, the FRONT of the sensor will have:
^
A foam ring (4)
^
A pin hole (7) for the centering pin-Note the location of the pin hole.
^
A flushed rotor flange cuff (6)
^
An alignment mark (5) for installation
6. From the technicians point of view, the BACK of the sensor will have:
^
Double D flats (1)
^
A foam ring (3)
