Sierra Classic 2500 4WD V8-6.0L (2007)
4. Remove the shock absorber mounting bolt at the lower control arm, the 15 series.
5. The lower shock mounting bushing is serviceable by driving the bushing out with the appropriate tool.
6. Remove the shock absorber mounting bolt (2) at the lower control arm, the 25 series.
7. Remove the shock absorber.
Installation Procedure
1. Install the shock absorber. Insert the stem through the hole in the shock bracket on the frame.
2. Align the shock absorber with the mounting holes in the lower control arm, the 15 series.
3. Align the shock absorber with the mounting holes in the lower control arm, the 25 series.
4. Install the shock absorber through the bolt (2) to the lower control arm.
5. Notice:
Refer to Fastener Notice.
Install the shock absorber through the bolt nut (3).
Tighten the nut to 80 Nm (59 ft. lbs.).
