Sierra Classic 2500 4WD V8-6.0L (2007)
2. Obtain J 43909 and remove the inner sleeve so that the tool will slide over the manual shift shaft.
3. Slide the J 43909 into position so that the end of the tool contacts the seal being installed. Use a mallet to strike the J 43909 and drive the new seal
into the seal bore until the seal is seated at the bottom of the bore.
Manual Shift Shaft, Detent Lever, and Position Switch Assembly Replacement
Manual Shift Shaft, Detent Lever, and Position Switch Assembly Replacement
Removal Procedure
1. Remove the control valve assembly from the transmission. Refer to Control Valve Body Replacement.
2. Important:
The detent lever/IMS retaining bolt contains patch lock material on the threads. Do not reuse the retaining bolt.
Remove the detent lever/IMS retaining bolt (1) using a T27 TORX(r) bit and discard the retaining bolt.
3. Notice:
DO NOT mar the transmission case surface around the spherical pin when removing or installing the spherical pin. An unmarred surface is
required to maintain the seal between the control valve assembly and the transmission case.
Notice:
DO NOT twist the spherical pin when removing the pin from the transmission case. Damage to the transmission case can occur.
Place a protective plate on the transmission case surface around the spherical pin (3). Remove the spherical pin (3) from the transmission case.
4. Slide the manual shift shaft (5) through the detent lever/IMS assembly (4) and through the manual shift shaft seal.
5. Rotate the detent lever/IMS assembly to disengage the park pawl apply assembly (2). Remove the detent lever/IMS assembly (4).
Installation Procedure
