Sierra Classic 2500 4WD V8-6.0L (2007)
Tighten the bolt to 25 Nm (18 ft. lbs.).
14. Install the I/P center support bracket bezel (1).
15. Install the I/P assembly retaining bolts (3) and nuts (4). Ensure the wire harness is routed to all of the openings.
Tighten the retaining bolts and nuts to 9 Nm (80 inch lbs.).
16. Install the harness hold down retainers to the I/P assembly.
17. Connect the electrical connector (1) to the ambient light sensor on the underside of the trim panel.
18. Install the trim panel to the I/P assembly.
