Sierra Classic 2500 4WD V8-6.0L (2007)
6. Using an inch-pound torque wrench, measure the amount of torque required to rotate the pinion. Record this measurement for reassembly. This
will give the combined preload for the following components:
^
The pinion bearings
^
The pinion oil seal
^
The differential case bearings
^
The axle bearings
^
The axle seals
7. Place an alignment mark between the pinion and the pinion yoke.
8. Install the J 8614-01 as shown.
9. While holding the J 8614-01, loosen the pinion nut.
10. Remove the washer.
