Sierra Classic 2500 4WD V8-6.0L (2007)
8. Using side cutters, remove the small boot retaining clamp.
9. Remove the following items from the halfshaft bar:
1. The spacer ring (1)
2. The tripot spider assembly (2)
3. The tripot boot (3)
10. Clean the halfshaft bar (4). Use a wire brush in order to remove any rust in the seal mounting area (grooves).
11. Inspect the needle rollers, needle bearings, and trunnion. Inspect the tripot housing for unusual wear, cracks, or other damage. Replace any
damaged parts with the appropriate service kit.
Installation Procedure
