Sierra Classic 2500 4WD V8-6.0L (2007)
4. Position the input shaft bearing retainer. Align the bearing retainer oil drain hole with the drain hole in the transmission housing.
5. Notice:
Refer to Fastener Notice.
Install the input shaft bearing retainer bolts.
Tighten the bolts to 14 Nm (10 ft. lbs.).
6. Install the clutch actuator cylinder and the bolts.
Tighten the bolts to 8 Nm (71 inch lbs.).
7. Install the transmission. Refer to Transmission Replacement.
8. Lower the vehicle.
Transmission Housing Oil Seal Replacement - Rear
Transmission Housing Oil Seal Replacement - Rear (4WD)
Tools Required
^
J 36825 Output Shaft Oil Seal Remover
^
J 23907 Slide Hammer
^
J 36502-2A Output Shaft Oil Seal Protector
^
J 36502 Extension Housing Seal Installer
Removal Procedure
