Sierra Classic 2500 4WD V8-6.0L (2007)
Seals and Gaskets: Service and Repair
NVG 261-NP2 - Transfer Case
Transfer Case Output Shaft Seal Replacement - Front
Transfer Case Output Shaft Seal Replacement - Front
Tools Required
^
J 8092 Drive Handle
^
J 43484 Output Shaft Seal Installer
Removal Procedure
1. Remove the transfer case shield, if equipped. Refer to Transfer Case Shield Replacement.
2. Remove the front propeller shaft. Refer to Front Propeller Shaft Replacement.
3. Insert a flat-tipped screwdriver into the inner race.
4. Pry the inner race back.
5. Insert a small pry bar into the inner race.
6. Remove the inner part of the seal.