Sierra Classic 2500 4WD V8-6.0L (2007)
1. Install the J 43484 (2) to the J 8092 (1).
2. Install the seal onto the J 43484 (2).
3. Using the J 43484 (2) and the J 8092 (1), install the seal.
4. Install the front propeller shaft. Refer to Front Propeller Shaft Replacement.
5. Check the fluid level, add fluid if necessary.
6. Install the transfer case shield, if equipped. Refer to Transfer Case Fluid Replacement.
Transfer Case Output Shaft Seal Replacement - Rear
Transfer Case Output Shaft Seal Replacement - Rear
Tools Required
^
J 37668-A Seal Installer
^
J 45380 Transfer Case Rear Bushing Remover and Installer
Removal Procedure
1. Remove the transfer case shield, if equipped. Refer to Transfer Case Shield Replacement.
2. Remove the rear propeller shaft. Refer to One-Piece Propeller Shaft Replacement or Two-Piece Propeller Shaft Replacement.
3. Remove the rear output shaft seal.
