Sierra Classic 2500 4WD V8-6.0L (2007)
1. Notice:
Refer to Fastener Notice.
Install the left rear speed sensor.
Tighten the speed sensor to 15 Nm (11 ft. lbs.).
2. Connect the left rear speed sensor electrical connector (4).
3. Lower the vehicle.
Transfer Case Rear Output Shaft Speed Sensor Replacement - Right Side
Transfer Case Rear Output Shaft Speed Sensor Replacement - Right Side
Removal Procedure
1. Raise and suitably support the vehicle. Refer to Vehicle Lifting.
2. Disconnect the right rear speed sensor electrical connector (3).
