Sierra Classic 2500 4WD V8-6.0L (2007)
1. Install the locating pins to the NEW encoder motor.
2. Position a NEW actuator insulator gasket to the transfer case.
3. Install the encoder motor.
Notice:
Refer to Fastener Notice.
4. Install encoder motor bolts.
Tighten the bolts, in the sequence shown, to 20 Nm (15 ft. lbs.).
5. Connect the encoder motor electrical connector. Ensure that the retention clips activate.
6. Install the front propeller shaft. Refer to Front Propeller Shaft Replacement.
7. Install the transfer case shield, if equipped. Refer to Transfer Case Shield Replacement.
