Sierra Classic 2500 4WD V8-8.1L (2007)
Garage Door Opener Transmitter: Service and Repair
Garage Door Opener Replacement
Removal Procedure
1. Remove the console roof screw.
2. Disconnect the electrical connectors.
3. Remove the console from vehicle.
4. Disconnect the electrical connector from the garage door opener.
5. Remove the garage door opener retaining screws.
6. Remove the garage door opener from the overhead console.
Installation Procedure
1. Install the garage door opener to the overhead console.
Notice: Refer to Fastener Notice.
2. Install the garage door opener retaining screws.
Tighten the retaining screws to 2 N.m (18 lb in).
3. Connect the electrical connector to the garage door opener.
4. Install the console to the roof.
5. Connect the electrical connectors.
6. Install the overhead console retaining screw.
Tighten the overhead console retaining screw to 2 N.m (18 lb in).
7. Refer to Control Module References for programming and setup information. See: Testing and Inspection/Programming and Relearning
