Sierra Classic 2500 4WD V8-8.1L (2007)
9. To replace the engine electrical center bracket remove the 4 retaining bolts (1).
10. Remove the engine electrical center bracket assembly from the fender.
INSTALLATION PROCEDURE
1. Install the engine electrical center bracket assembly to the front fender.
2. NOTE: Refer to Fastener Notice.
Install the 4 retaining bolts (1).
Tighten the 4 retaining bolts (1) to 9 N.m (80 lb in).
3. Align the electrical center block (1) stubs in the slots so that the tabs (2) retains it in place.
4. Connect the wire connectors to the lower portion of the electrical center block.
5. Connect the wire connectors with the bolts to the electrical center block.
Tighten all connector bolts (1) to 9 N.m (80 lb in).
6. Ensure all wire connectors are securely connected.
7. Set the electrical center block in its resting position till the tabs (3) locks in place.
