Sierra Classic 2500 4WD V8-8.1L (2007)
Installation Procedure
1. Connect the outer tie rod assembly (3) to the inner tie rod (1). Do not tighten the jam nut (2).
2. Install the tie rod seal (2) to the outer tie rod assembly (1).
3. Connect the outer tie rod assembly (1) to the steering knuckle (2).
Notice:
Refer to Fastener Notice.
4. Install the torque prevailing nut (3) to the outer tie rod stud (1).
Tighten the torque prevailing nut (3) to 50 Nm (37 ft. lbs.).
5. Important:
Be sure the rack and pinion boot is not twisted after the toe adjustment.
Check the wheel alignment. Refer to Measuring Wheel Alignment.