Sierra Classic 2500 4WD V8-8.1L (2007)
5. Push the clutch master cylinder in until the pushrod socket is touching the clutch pedal.
6. Push in and rotate the clutch master cylinder 45 degrees counterclockwise to the locked position.
7. Install the clutch master cylinder clip to the brake pressure module valve pipe.
8. Apply light pressure to the clutch pedal to couple the pushrod socket to the clutch pedal.
9. Connect the clutch pedal engine start switch electrical connector (1).
10. Pump the clutch pedal 3 times prior to starting the vehicle to ensure connection is complete.
11. Install the I/P carrier top bolts (1).
Tighten the bolts to 50 Nm (37 ft. lbs.).
12. Install the left side cowl trim and sill plate. Refer to Front Side Door Sill Plate Replacement.
13. Install the I/P center support bracket bolt.
