Sierra Classic 3500 2WD V8-6.6L DSL Turbo (2007)
1. Install the spring, diaphragm, and cover.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the PCV cover screws.
Tighten the screws to 4 Nm (35 inch lbs.).
3. Remove the tape from the turbocharger openings.
Important: Lubricate the end of the duct prior to installation.
4. Install the charged air cooler inlet duct connector (4) to the turbocharger.
5. Tighten the charged air cooler inlet duct connector to turbocharger clamp (1).
Tighten the clamp to 6 Nm (53 inch lbs.).
