Sierra Classic 3500 4WD V8-6.0L (2007)
4. Tighten the bolt on J 29714-A in order to compress the servo cover.
5. Install the servo cover ring.
6. Remove the J 29714-A.
7. Notice:
Refer to Fastener Notice.
Install the oil pan bolt.
Tighten the bolt to 11 Nm (97 inch lbs.).
8. Install the heat shield and bolts.
Tighten the bolts to 17 Nm (13 ft. lbs.).
9. Install the exhaust pipe. Refer to Exhaust Manifold Pipe Replacement (6.0L, and 8.1L Engines).
10. Fill the transmission to the proper level with DEXRON(r) VI transmission fluid. Refer to Transmission Fluid Check.
11. Important:
It is recommended that transmission adaptive pressure (TAP) information be reset.
Resetting the TAP values using a scan tool will erase all learned values in all cells. As a result, The ECM, PCM or TCM will need to relearn TAP
values. Transmission performance may be affected as new TAP values are learned.
Reset the TAP values. Refer to Transmission Adaptive Functions.
