Sierra Classic 3500 4WD V8-6.0L (2007)
4. Install the fill tube bracket nut.
5. Lower the vehicle.
Notice:
Refer to Fastener Notice.
6. Install the oil level indicator.
Tighten the nut to 47 Nm (35 ft. lbs.).
7. Fill the transmission to the proper level with Dexron(r) III transmission fluid. Refer to Transmission Fluid Check.
Manual Shift Shaft Seal Replacement
Manual Shift Shaft Seal Replacement
Tools Required
^
J 43911 Selector Shaft Seal Remover
^
J 43909 Selector Shaft Seal Installer
Removal Procedure
1. Remove the park/neutral position (PNP) switch. Refer to Park/Neutral Position Switch Replacement.
2. Ensure that the jackscrew for J 43911 is backed off and will not interfere with installation of the removal tool. Slide the seal remover tool over the
selector shaft (2) with the threaded end of the tool towards the seal.
3. Rotate the J 43911 so that the threads on the end of the tool engage the steel shell (1) of the seal. Use a wrench to be sure that the removal tool is
firmly attached to the seal shell.
4. Rotate the jackscrew in the clockwise direction to remove the seal from the bore. Discard the seal that was removed.
Installation Procedure