Sierra Classic 3500 4WD V8-6.0L (2007)
Power Take-Off: Service and Repair
Power Take-Off Switch Replacement
Removal Procedure
1. Remove the I/P cluster bezel. Refer to Instrument Panel Cluster Trim Plate Bezel Replacement.
2. Pull out the switch housing from the I/P.
3. Disconnect the wire connector to the PTO switch.
4. Remove the PTO switch from the switch housing.
Installation Procedure
1. Install the PTO switch to the housing
2. Connect the wire connector to the switch.
3. Install the switch housing to the I/P till it clicks into place.
