Sierra Classic 3500 4WD V8-8.1L (2007)
3. Dry the reservoir with non-lubricated, filtered air.
4. Lubricate the new seals and the outer surface area of the reservoir-to-housing barrels with Delco Supreme II® (GM P/N 12377967) or equivalent
DOT-3 brake fluid from a clean, sealed brake fluid container.
5. Install the lubricated seals, make sure they are fully seated.
6. Install the reservoir to the master cylinder by pressing the reservoir straight down on the master cylinder until the pin holes are aligned.
7. Carefully install the reservoir retaining pins to secure the reservoir.
8. Place the brake fluid level sensor into the reservoir, press into place to secure the sensor retaining tabs.
9. Remove the master cylinder from the vice.
10. Install the master cylinder.
11. Release the park brake.
12. Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Manual).
