Sierra Classic 3500 4WD V8-8.1L (2007)
Front Steering Knuckle: Service and Repair
Steering Knuckle Replacement (4WD)
Tools Required
^
J 43631 Ball Joint Remover
^
J 45851 Ball Joint Separator Protector Adapters
^
J-42188-B Ball Joint Separator
Removal Procedure
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the tire and wheel.
3. Remove the wheel hub and bearing assembly.
4. Support the lower control arm with a suitable jack.
5. Disconnect the outer tie rod to the steering knuckle.
6. Remove the brake hose bracket retaining bolt from the steering knuckle.
7. Remove the upper control arm retaining nut and separate the upper ball joint from the steering knuckle using the J-42188-B.
