Sierra Classic 3500 4WD V8-8.1L (2007)
1. Install the control lever assembly.
2. Notice:
Refer to Fastener Notice.
Install the control lever bolts.
Tighten the bolts to 12 Nm (106 inch lbs.).
3. Install the control lever bezel.
4. Install the control lever bezel screws.
Tighten the screws to 2 Nm (18 inch lbs.).
5. Install the control lever knob.
6. Raise and suitably support the vehicle. Refer to Vehicle Lifting.
7. Install the shift control rod. Refer to Transfer Case Control Rod Replacement.
8. Install the front propeller shaft. Refer to Front Propeller Shaft Replacement.
9. Install the transfer case shield, if equipped. Refer to Transfer Case Fluid Replacement.
