Sierra Denali V8-6.0L VIN N (2005)
4. Install the anti-rattle clips to the brake caliper bracket.
5. Install the brake pads.
6. Slide the brake pads in until they contact the rotor.
7. Install the brake caliper bolts.
Tighten the bolts to 108 Nm (80 ft. lbs.).
8. Install the tire and wheel assembly.
9. With the engine OFF, gradually apply the brake pedal to approximately 2/3 of its travel distance.
10. Slowly release the brake pedal.
11. Wait 15 seconds, then repeat steps 10-11 until a firm pedal is obtained. This will properly seat the caliper pistons and pads.
12. Fill the master cylinder reservoir to the proper level with clean brake fluid, if necessary.
W/O NYS
Brake Caliper Bracket Replacement - Rear (1500 Series w/o NYS)
Caution: Refer to Brake Dust Caution in Service Precautions.
Removal Procedure
1. Inspect the fluid level in the brake master cylinder reservoir.
