Sierra Denali V8-6.0L VIN N (2005)
7. Install the brake caliper bolts.
Tighten the bolts to 42 Nm (31 ft. lbs.).
8. Install the tire and wheel assembly.
9. With the engine OFF, gradually apply the brake pedal to approximately 2/3 of its travel distance.
10. Slowly release the brake pedal.
11. Wait 15 seconds, then repeat steps 10-11 until a firm pedal is obtained. This will properly seat the caliper pistons and pads.
12. Fill the master cylinder reservoir to the proper level with clean brake fluid, if necessary.
W/NYS
Brake Caliper Bracket Replacement - Rear (1500 Series w/NYS, 25/3500 Series)
Caution: Refer to Brake Dust Caution in Service Precautions.
Removal Procedure
1. Inspect the fluid level in the brake master cylinder reservoir.
2. If the fluid level is midway between the maximum - full point, and the minimum allowable level, no fluid needs to be removed from the reservoir
before proceeding.
3. If the fluid level is higher than midway between the maximum - full point, and the minimum allowable level, remove fluid to the midway point
before proceeding.
4. Remove the tire and wheel assembly.
5. Compress the brake caliper pistons.
1. Install a large C-clamp over the top of the caliper housing and against the back of the outboard pad.
2. Slowly tighten the C-clamp until the pistons are pushed completely into the caliper bores.
3. Remove the C-clamp from the caliper.
6. Loosen the rear brake caliper mounting bolts. Do not remove.
