Sierra Denali V8-6.0L VIN N (2005)
1. Install the anti-rattle clips to the caliper bracket.
2. Install the brake pads.
3. Install the caliper to the caliper bracket.
4. Install the brake caliper bolts to the caliper bracket. DO NOT tighten.
5. Install the caliper and caliper bracket (1) as an assembly.
6. Perform the following procedure before installing the caliper bracket bolts.
1. Remove all traces of the original adhesive patch.
2. Clean the threads of the bolt with denatured alcohol or equivalent and allow to dry.
3. Apply Threadlocker GM P/N 12345493 (Canadian P/N 10953488) to the threads of the bolt.
7. Notice: Refer to Fastener Notice in Service Precautions.
Install the brake caliper bracket bolts (2).
Tighten the bolts to 300 Nm (221 ft. lbs.).
8. Tighten the brake caliper bolts (2).
Tighten the bolts to 108 Nm (80 ft. lbs.).
9. Install the tire and wheel assembly.
10. With the engine OFF, gradually apply the brake pedal to approximately 2/3 of its travel distance.
11. Slowly release the brake pedal.
