Power Steering Cooler Pipe/Hose Replacement (With Hydroboost)
3. Install the booster outlet hose to the power steering pump nipple and retaining clamp (2).
4. Install the booster inlet hose (1) to the booster.
5. Install the gear inlet hose to the booster.
^
Tighten both power steering inlet hose fittings to 32 Nm (24 ft. lbs.).
Notice: Refer to Fastener Notice in Service Precautions.
6. Install the booster outlet hose (3) to the booster and install the retaining clamp (2).
7. Remove the drain pan from under the vehicle.
8. Bleed the power steering system.
9. Connect the energy storage box before after servicing the vehicle.
Power Steering Gear Inlet Pipe/Hose Replacement (With Hydroboost)
Power Steering Gear Inlet Pipe/Hose Replacement (With Hydroboost)
Removal Procedure
