Sierra Denali V8-6.0L VIN N (2005)
9. Once the specified torque is obtained, rotate the pinion several times to ensure the bearings have seated. Recheck the rotating torque and adjust if
necessary.
10. Install the propeller shaft (3) to the pinion yoke (4). Align the reference marks made during removal.
11. Install the propeller shaft yoke retaining clamps and the bolts.
^
Tighten the propeller shaft yoke retaining clamp bolts to 25 Nm (18 ft. lbs.).
12. Install the axle shafts (10.5 inch, 11.5 inch axle).
13. Install the brake rotors (8.6 inch, 9.5 inch axles).
14. Install the brake calipers (8.6 inch, 9.5 inch axles).
15. Install the tire and wheel assemblies.
16. Inspect and add axle lubricant to the axle housing, if necessary.
17. Lower the vehicle.
Drive Pinion Housing and/or Seal Replacement
Drive Pinion Housing and/or Seal Replacement
^
Tools Required
-
J 44414 Pinion Seal Installer
-
J 22912-01 Bearing Puller
-
J 24433 Pinion Cone and Side Bearing Installer
-
J 37624 Pinion Bearing Installer
-
J 8092 Driver Handle
-
J 8608 Rear Pinion Bearing Race Installer
-
J 8614-01 Flange/Pulley Holding Tool
Removal Procedure
1. Raise the vehicle. Refer to Vehicle Lifting.
Important: Observe and mark the positions of all the driveline components, relative to the propeller shaft and the axles, prior to disassembly.
These components include the propeller shafts, drive axles, pinion flanges, output shafts, etc. Reassemble all the components in the exact places in
which you removed the parts. Follow any specifications, torque values, and any measurements made prior to disassembly.
2. Drain the axle lubricant.
3. Remove the axle shafts.
4. Reference mark the rear propeller shaft (3) to the rear axle pinion yoke (4).
5. Disconnect the propeller shaft from the axle. Wrap the bearing caps with tape in order to prevent the loss of bearing rollers. Support the propeller
