Sierra Denali AWD V8-6.2L (2008)
6. Disconnect the rear sliding window electrical connectors from the motor/module and relays (1).
7. Remove the rear sliding window motor/module assembly from the vehicle.
Installation Procedure
1. Install the rear sliding window motor/module assembly to the vehicle.
2. Connect the rear sliding window electrical connectors to the motor/module and relays (1).
Notice: Refer to Fastener Notice.
3. Install the rear sliding window motor/module nuts (2).
Tighten nut to 10 N.m (89 lb in).
4. Install the rear sliding window regulator and cables (2) to the motor/module.
5. Install the bolt (1) to the rear sliding window regulator and cables (2).