Sierra Denali AWD V8-6.2L (2008)
Engine Mount: Service and Repair
Engine Mount Replacement - Right
Engine Mount Replacement - Right Side (1500 LH6, LMG, LY5, L76 and L92) (5.3L,6.0L and 6.2L)
Removal Procedure
Notice: When raising or supporting the engine for any reason, do not use a jack under the oil pan, any sheet metal, or the crankshaft pulley. Due to the
small clearance between the oil pan and the oil pump screen, jacking against the oil pan may cause the pan to be bent against the pump screen. This will
result in a damaged oil pickup unit.
1. Remove the upper intake manifold sight shield. Refer to Upper Intake Manifold Cover Replacement (See: Intake Manifold/Service and Repair) .
2. If the vehicle is equipped with four wheel drive (4WD), remove the front drive axle. Refer to Differential Carrier Assembly Replacement (1500
FWD) Differential Carrier Assembly Replacement (2500 4WD) .
3. Remove the two lower engine mount to engine bolts (1).
4. Remove the starter motor. Refer to Starter Motor Replacement (4.3L) Starter Motor Replacement (4.8L, 5.3L, 6.0L, and 6.2L) Starter Motor
Replacement (6.6L) .
