Sierra Denali AWD V8-6.2L (2008)
3. If not equipped with active fuel management, perform the following step, using J 41712 or equivalent. Install the oil pressure sensor (706) and
washer (707).
4. Connect the engine harness electrical connector (1) to the oil pressure sensor.
Tighten the sensor to 35 N.m (26 lb ft).
5. Install the intake manifold. Refer to Intake Manifold Replacement (L92 - First Design) (See: Engine, Cooling and Exhaust/Engine/Intake
Manifold/Service and Repair)Intake Manifold Replacement (L92 - Second Design) (See: Engine, Cooling and Exhaust/Engine/Intake
Manifold/Service and Repair)Intake Manifold Replacement (LY2 and LY6) (See: Engine, Cooling and Exhaust/Engine/Intake Manifold/Service
and Repair)Intake Manifold Replacement (LH6, LMG, LY5 and L76) (See: Engine, Cooling and Exhaust/Engine/Intake Manifold/Service and
Repair) .