Sierra Denali AWD V8-6.2L (2008)
3. Install the axle shaft bearing using the J 23690 (1) and the J 8092 (2).
4. Drive the axle shaft bearing into the axle housing until the tool bottoms against the tube.
5. Install the axle shaft seal using the J 21128 .
6. Drive the tool into the bore until the axle shaft seal bottoms flush with the tube.
7. Install the axle shaft. Refer to Rear Axle Shaft Replacement (8.6 Inch Axle w/Drum Brake w/VSES) Rear Axle Shaft Replacement (8.6 Inch Axle
w/Drum Brakes w/o VSES) Rear Axle Shaft Replacement (8.6, 9.5 Inch Axles w/VSES) .
8. Install the rear axle housing cover. Refer to Rear Axle Housing Cover and Gasket Replacement .
9. Install the rear wheel speed sensor. Refer to Rear Wheel Speed Sensor Replacement (See: Rear Wheel Speed Sensor Replacement) .
10. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
11. Fill the rear axle. Refer to Rear Axle Lubricant Replacement (8.6 Inch Axle) Rear Axle Lubricant Replacement (9.5 Inch LD Axle) Rear Axle
Lubricant Replacement (10.5 Inch Axle) .
12. Lower the vehicle.