Sierra Denali AWD V8-6.2L (2008)
Center Link: Service and Repair
Relay Rod Replacement
Tools Required
J 24319-B Steering Linkage and Tie Rod Puller
Removal Procedure
1. Remove the engine shield, if equipped. Refer to Engine Shield Replacement .
2. Remove the steering linkage shock absorber from the relay rod, if equipped. Refer to Steering Linkage Shock Absorber Replacement (See:
Steering Damper/Service and Repair) .
Important: Discard the idler arm nut (6) and the pitman arm nut (4).
3. Remove the steering linkage inner tie rods (3). Refer to Steering Linkage Inner Tie Rod Replacement (See: Tie Rod/Service and Repair/Steering
Linkage (Non-Rack & Pinion)) .
4. Remove the idler arm nut (6) and separate the idler arm (1) from the relay rod (5) using puller J 24319-B .
5. Remove the pitman arm nut (4) and separate the pitman arm (2) from the relay rod (5) using puller J 24319-B .
6. Remove the relay rod (5) from the vehicle.
7. Inspect the threads and seals on all steering related components. Repair or replace components as needed.
Installation Procedure