Sierra Denali AWD V8-6.2L (2008)
^
Inspect transmission filter for any cracks, holes or split seams that may allow air to be sucked into the pump.
^
Inspect the check balls for roundness ensuring that there are no flat spots.
^
Measure all the valve body bore plugs (328) for diameter. The specification is 11.502 mm +/- 0.004 mm. Undersize bore plugs should be replaced.
^
Inspect clutch select valve 2 (352) (Closest to the manual valve) in the lower valve body (351) for freedom of movement and travel.
^
Inspect CBR1/ C456 Reg Valve (327) in the upper valve body (321) for freedom of movement and travel.
^
Perform Control Solenoid Valve and Transmission Control Module Assembly Solenoid Performance Test (SI Document ID # 1618572) to determine
if shift solenoid # 1 is functioning properly.
Important:
The seals included in plate kit, P/N 24236934, should be replaced when the valve body is assembled. Do not reuse the old seals.
^
Replace the spacer plate with P/N 24245720. This spacer plate makes use of a revised gasket to help reduce the occurrence of DTC P0751.