Sierra Denali AWD V8-6.2L (2008)
Constant Velocity Joint: Service and Repair
Wheel Drive Shaft Outer Joint and Boot Replacement
Wheel Drive Shaft Outer Joint and Boot Replacement
Tools Required
*
J 8059 Snap Ring Pliers
*
J 35910 Drive Axle Seal Clamp Pliers
*
J 36652-1 Drive Axle Clamp Swage Tool
*
J 36652-2 Axle Swage Tool
Removal Procedure
1. Remove the wheel drive shaft. Refer to Wheel Drive Shaft Replacement (2500) ()Wheel Drive Shaft Replacement (1500) () .
2. Remove the wheel drive shaft seal cover, if applicable. Refer to Wheel Drive Shaft Seal Cover Replacement (See: Service and Repair) .
Important: Use caution when using the hand grinder by the CV joint outer race (1).
3. Use a hand grinder to cut through the swage ring (2).
4. Use side cutters to cut off the small boot clamp (4).