Sierra Denali Classic AWD V8-6.0L (2007)
INSTALLATION PROCEDURE
1. Position the accelerator pedal to the accelerator pedal bracket.
NOTE: Refer to Fastener Notice.
2. Install the accelerator pedal bolts.
Tighten the bolts to 9 N.m (80 lb in).
3. Connect the APP sensor electrical connector (1).
4. Install the CPA retainer.
5. Connect a scan tool to the diagnostic port in order to test for proper throttle-opening and throttle-closing range.
6. Operate the accelerator pedal and monitor the throttle angles. The accelerator pedal should operate freely, without binding, between a closed
throttle, and a wide open throttle (WOT).
7. Verify that the vehicle meets the following conditions: