Sierra Denali RWD V8-6.2L (2009)
2. Install each of the new wheel studs into the hub and rotor assembly by performing the following:
1. Install the stud.
2. Install 4 washers to the stud.
3. Install a lug nut to the stud with the flat side of the nut toward the washers.
4. Tighten the lug nut to draw the stud into the hub and rotor assembly.
5. Inspect the hub and rotor assembly to ensure the stud is seated completely.
6. Remove the lug nut and the washers.
3. Install the hub and rotor assembly to the vehicle. Refer to Rear Axle Hub, Bearing, Cup, and/or Seal Replacement (See: Transmission and
Drivetrain/Drive Axles, Bearings and Joints/Axle Bearing/Service and Repair/Rear Axle Hub, Bearing, Cup, and/or Seal Replacement) .
4. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (See: Maintenance/Wheels and Tires/Service and Repair) .
5. Lower the vehicle.
