Sierra Denali RWD V8-6.2L (2009)
Cruise Control: Testing and Inspection
Cruise Control Malfunction
Cruise Control Malfunction
Diagnostic Instructions
*
Perform theDiagnostic System Check - Vehicle (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic System
Check - Vehicle) prior to using this diagnostic procedure.
*
ReviewStrategy Based Diagnosis (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Strategy Based Diagnosis) for an
overview of the diagnostic approach.
*
Diagnostic Procedure Instructions (See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnostic Procedure Instructions)
provides an overview of each diagnostic category.
Diagnostic Fault Information
Circuit/System Description
The body control module (BCM) supplies battery voltage to the cruise control switch. The cruise control switch signal is an input to the BCM. The BCM
monitors the cruise control switch signal circuit in order to detect when the driver has requested to perform a cruise control function. The BCM detects a
specific voltage signal on the cruise control switch signal circuit when a switch is applied.
Reference Information
Schematic Reference
*
Cruise Control Schematics (See: Diagrams/Electrical Diagrams)
*
Steering Wheel Secondary/Configurable Control Schematics (See: Accessories and Optional Equipment/Diagrams/Electrical Diagrams/Steering
Wheel Secondary/Configurable Control Schematics)
Connector End View Reference
Component Connector End Views (See: Diagrams/Connector Views)
Description and Operation
Cruise Control Description and Operation (See: Description and Operation)
Electrical Information Reference
*
Circuit Testing (See: Testing and Inspection/Component Tests and General Diagnostics)
*
Connector Repairs (See: Testing and Inspection/Component Tests and General Diagnostics)
*
Testing for Intermittent Conditions and Poor Connections (See: Testing and Inspection/Component Tests and General Diagnostics)
*
Wiring Repairs (See: Testing and Inspection/Component Tests and General Diagnostics)
Scan Tool Reference
Control Module References (See: Testing and Inspection/Programming and Relearning) for scan tool information
Circuit/System Verification
Engine ON, while rotating the steering wheel to both steering stops, observe the scan tool Cruise Control Switch parameter while pressing each of the
cruise control switches. The parameter should toggle between On, Off, Resume, Set, and Cancel as the applicable switch is pressed.
Circuit/System Testing
1. Ignition OFF, disconnect the harness connector at the steering wheel controls switch - left.
2. Ignition ON, test for B+ between the B+ circuit terminal 1 and ground.