Sierra Denali RWD V8-6.2L (2009)
3. Install the USED crankshaft balancer bolt (139).
Tighten the USED bolt to 330 Nm (240 lb ft).
4. Remove the USED crankshaft balancer bolt.
Note
The nose of the crankshaft should be recessed 2.4-4.48 mm (0.094-0.176 in) into the balancer bore.
5. Measure for a correctly installed balancer. If the balancer is not installed to the proper dimension, install the J 41665 and repeat the installation
procedure.
