Sierra Denali RWD V8-6.2L (2009)
![background image](/gmc/sierra_denali_rwd/v8-6.2l/Page-1077002.png)
8. Take a CLEAR digital picture of the Tech 2(R) Vehicle Information screen showing the engine Calibration IDs and Verification Numbers as
shown above. Retain the printout information and the Tech 2(R) screen photograph with the repair order.
Note
All pictures must be sent as a.jpg file.
9. E-mail a copy of the picture to [email protected]. In the subject line of the e-mail include the phrase "V8 Cal" as well as the complete VIN
and Dealer BAC. In the body of the e-mail, include the VIN, mileage, R.O. number and BAC. Include a brief description of the customer concern
and cause of the concern.
Note
The dealer will receive an e-mail reply after the calibrations have been validated. The e-mail reply will advise the dealer if the calibrations are
OEM.
10. Allow two hours for the PQC to verify the calibrations and set up the case details.
‹› If the PQC determines that the calibrations ARE aftermarket calibrations, DO NOT contact GM Technical Assistance to discuss warranty
concerns on the aftermarket calibrations. ALL questions and concerns about warranty should be directed to the dealers Fixed Operations
Manager (FOM), (Warranty Manager (WM) in Canada).
11. You may call the PQC two hours after submitting the e-mail for authorization to replace the assembly. This will provide them time to receive,
review and set up a case on the request. Please be prepared to provide all the usual documentation that is normally required when requesting an
assembly authorization from the PQC.
Tech 2(R) Displaying All Zeroes for the Verification Numbers on the Calibration ID and Verification Number Screen
If the Tech 2(R) that you are using displays all zeroes for the Verification Numbers as shown, then perform the following steps:
1. Update the Tech 2(R) with the latest software from TIS2WEB.
2. Turn OFF the ignition for 90 seconds.
3. Connect the Tech 2(R) to the vehicle.
4. Turn ON the ignition, and build the vehicle. Observe the Tech 2(R) Calibration ID and Verification Number screen for proper operation.
‹› If the Tech 2(R) screen still does not display properly, then turn OFF the ignition for 90 seconds again. Turn ON the ignition and observe the
same screen for proper operation.
Retrieving Calibrations From a Global A Vehicle
This information applies to the 2010 Camaro and is typical of the procedure that will be used on Global A vehicles.
1. Turn OFF the ignition.